The claw hammer manufacturer stated that in the application of the product, sometimes it will be affected by corrosion due to carelessness, so we need to pay more attention when using it to prevent it from being corroded. The following will follow the editor to learn a few ways to prevent the claw hammer. Corrosion measures!
In order to prevent the claw hammer from being corroded, the cutting edge of the claw hammer should be placed in the sink and lightly touched with the grinding wheel for sharpening. Do not use excessive force and contact with the grinding wheel for too long. And as far as possible to use and store in a dry environment, if it is impossible to avoid using in a humid environment, try to speed up the operation speed and reduce the working time to avoid the risk of causing greater corrosion. In the application, the knocked part should not be hit continuously, and there should be a suitable interval for more than ten times. At the same time, the debris adhered to the product part should be removed in time before continuing to use.
In actual operation, the debris on the site and the corroded oxide on the working surface must be removed to prevent impact, and it must be wiped clean in time after use. It is strictly forbidden to install and store with corrosive media.