1. Do not use the pliers handle as the pliers head
The use of pliers is practical with the left hand. With the jaws facing inward, it is good for manipulating the cutting position. Use your little finger to reach the middle of the two pliers handles against the pliers handles.
The common wire cutters for electric welders are 150, 175, 200 and 250mm. It can be purchased according to the technical requirements of the inside or outside line. The teeth of the pliers can also be used to tighten or unscrew the nut.
The pliers' wound can be used to cut the flexible cable eraser or plastic cable sheath.
The wound of pliers can also be used to cut cables and thin wires. When cutting No. 8 galvanized steel strip, use the cutting edge to cut back and forth around the surface twice, and then only need to pull it slightly, and the thin wire is broken.
It can also be used to disconnect hard wires such as cables and stainless steel wires.
The insulated plastic hose of the pliers is resistant to about 500V, and it has the ability to cut the cable by induction. Do not throw them during use to prevent damage to the insulated plastic hose.
2. Never use the pliers as a hammer.
Do not use a pair of pliers to cut the double-stroke induction electrification cable, it will cause a short circuit failure.
When using a pair of pliers to wrap the fixed hoop, the wire of the pliers pinches the thin wire and coils it clockwise.
Repair pliers, also known as needle-nose pliers, are one of the special tools commonly used by welders, especially those who are inside welders. The key is to cut single- and multi-core wires with narrow cable diameters and bends for single-strand power transmission line connectors, and to peel plastic cable jackets.
The actual operation method of bending the power line connector with needle-nose pliers is: first fold the wire knot to the left, and then close to the extruder screw and bend it clockwise to the right.
Needle-nose pliers are slightly reformed and can be used as wire stripping needle-nose pliers. The method is: use a electric drill to drill b0.8, b1.0mm 2 slots at the front end of the cutting edge of the needle-nose pliers, and then use a 1.2, 1.4mm twist drill to expand them. These two slots have a thin tooth surface. In that way, a sharp-nose pliers that can cut and strip the thread is changed!
